MPI proof cleanmode Gravure Japanese_Newspaper_OEM_Engine Lotem_400_Fiber_Head_Machine Lotem_800_Fiber_Head_Machine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_400/800_Proofing Trendsetter_NEWS Trendsetter_Series_4 Sets the proof clean mode when loading the carrier and receiver on the drum. When loading the carrier, there are two types of drum clean: pre-clean and post-clean. Pre-clean is done BEFORE the carrier is loaded to the drum: the Spectrum cleaning roller is raised against the drum and cleans the entire bare drum surface from LEC to TEC. Post-clean is done AFTER the carrier is loaded: the Spectrum cleaning roller is raised against the carrier and cleans the entire carrier surface from LEC to TEC. Prior to loading the receiver, there is an "online roller clean" which cleans the vacuum roller, cleaning roller, and tape roller. CleanMode can be set from 0 to 6: CleanMode = 0: No pre-clean, no post clean, and no online roller clean. This mode is not recommanded. CleanMode = 1 (Default): Pre-clean ONLY (once). This mode is recommended for typical proofing sites. CleanMode = 2: Post clean ONLY. This mode is not recommanded. CleanMode = 3: BOTH Pre-clean (once) and post clean (once), no online roller clean. This mode is recommended for FUJI sites. CleanMode = 4: Pre-clean (once), no post clean, online roller clean. This mode is recommended for dusty sites running Dupont. CleanMode = 5: Pre-clean (twice), no post clean, online roller clean. This mode is recommended for sites running processless plates. CleanMode = 6: Pre-clean (twice), post clean (once), online roller clean. This mode is recommended for dusty sites running processless plates. This parameter is available.

1

0 to 6

18-Jul-2003 Normal

..\..\ShowAllErrors.htmFirmware 1 Error Index

..\..\ShowAllCommands.htmFirmware 1 Command Index

..\..\ShowAllParameters.htmFirmware 1 Parameter Index

Updated: Thu Jul 17 07:24:06 2008 PST